The KW Electronic Damping Cancellation Kit for the BMW Z4 Type Z89 (KW part number 68510145) is a hardware module for the E89-generation Z4 roadster. It addresses the car's electronic damping control (EDC) system after the factory adaptive shocks are replaced. Fitting coilovers or other non-EDC dampers without a cancellation device commonly leaves suspension warnings and fault messages active, and owners on user forums describe this module as the way to stop them. Its main advantage over a software-only approach is that it leaves the car's programming untouched. One BMW forum poster noted that some dealers will not reprogram a vehicle that is not fully stock, which matters to anyone who expects future service.
Fitment is where buyers should be careful. Published model-year ranges for this kit differ, and the engine mapping (sDrive28i, sDrive30i, sDrive35i, sDrive35is) should be checked against your VIN before ordering. Owners on E89 forums have run KW coilovers with this module, and installation is mainly a wiring job rather than a suspension job. Owners on user forums warn that the original accelerating sensor cannot be secured to aftermarket shocks that lack its mounting perch. Searchers looking for BMW Z4 E89 EDC delete, coilover EDC fault codes, or Z4 sDrive35is electronic damping cancellation will find this module relevant.
Owners on user forums report that the OEM accelerating sensor cannot be mounted to aftermarket shocks that lack its perch. One owner described the variable sport steering function as lost once the stock adaptive system is bypassed, so confirm how your steering behaves after installation.
Owners on user forums describe a coding route for the E89: disconnecting the two EDC connectors at the DME box and disabling two EDC entries in the instrument cluster menu. One owner estimated the job at 20 to 30 minutes. Coding is a software change with different trade-offs than a plug-in module.
Published ranges differ between sources, so confirm your exact year and engine with KW before ordering.
This is an electrical install of moderate difficulty. Owners on BMW forums say wiring the module took about as long as the suspension swap itself, so plan a full afternoon with the car fully apart. Expect to secure the modules with zip ties or clips, as owners on other KW-equipped BMW chassis have done. Check the accelerating sensor before you button everything up, since forum owners report it cannot be remounted to shocks without the stock perch. If you would rather avoid hardware, owners on E89 forums describe coding instead: the DME box sits under the hood on the driver side at the firewall, and the two EDC connectors are at its rear.