The Baja Designs S2 Sport Work/Scene Pattern Pair (part 547816) is a set of two compact LED work lights with amber lenses, built on Baja Designs' S2 Sport platform. The manufacturer's spec listing gives a 12.42W, 0.9A draw per light, a rated LED life of 49,930 hours, a hard-coated polycarbonate lens, and a powder-coated cast aluminum housing with stainless steel hardware. Built-in overvoltage protection is also included. The amber lens suits dust, fog, and low-visibility work, and the Work/Scene pattern is meant for broad area lighting rather than distance. The manufacturer rates the S2 Sport line IP69K, meaning it is waterproof to 9 feet and can be pressure washed, which is the durability case for paying more than for generic pods.
Because the S2 Sport is a universal product, it fits virtually any mounting location that can hold a bracket, including roof racks, bumpers, A-pillars, and rear cargo areas for backup or dust lighting. The manufacturer lists this part under its universal product line, so you are not restricted to a specific vehicle year, make, or model. Bolt-on mounting with stainless hardware and a sealed, cast housing make it a better long-term choice for off-road trail-rig upgrades or overland camp-light setups than thin-walled budget pods. Search terms that match this product include amber Work/Scene LED pod pair, S2 Sport 547816 install, IP69K amber scene light, and universal off-road LED work light pair.
The manufacturer lists the S2 Sport Work/Scene amber pair in its universal product category, so it is not designed for a single year, make, or model. Mounting depends on the location and bracket you choose rather than on a vehicle-specific kit.
The manufacturer's listing for this pair states that a wiring harness is included. Other listings disagree on this point, so confirm the harness contents with the manufacturer before ordering. The manufacturer identifies harness 640117 as the applicable harness for S2 Sport lights.
Yes. The manufacturer's installation guidance states that Baja Designs lights must have circuit protection, either a fuse or a circuit breaker, as with any electrical accessory.
The manufacturer rates the S2 Sport lights IP69K, which it describes as waterproof up to 9 feet and pressure washable.
The manufacturer publishes a dedicated installation sheet for part 547816, so review it before you drill anything. The manufacturer's general S1/S2 guidance covers both bracket mounting and flush mounting. For flush mounting, it calls for tracing a template on the mounting surface, marking the four outer holes, and drilling with an 11/64-inch bit, then reinstalling with the supplied hardware. Bracket mounts use the supplied stainless hardware. Install a fuse or breaker in the power line, and confirm the wiring harness before running wires. Check that the mounting location clears the light body and any wiring path, and verify the pair's harness and hardware contents against the manufacturer's sheet. Users who shop for mounting brackets should confirm the bracket style matches the mounting surface before purchase.
