This kit pairs two compact S2 Pro flush-mount pods with a wide cornering optic and clear lenses, for buyers who want a low-profile auxiliary or reverse light without a bracket hanging off the bumper. The housing is hard anodized and powder coated cast aluminum with a hardcoated polycarbonate lens, and the mounting hardware is stainless steel. The manufacturer rates each light at 2,245 raw lumens at 1.7A and 23.46 watts, which keeps the electrical load modest on a truck or UTV already running winches, fans, and accessories. Its value over a generic pod is the engineered optic and the manufacturer's sealed, rugged build, which matter on rough night trails. The manufacturer says the flush design can be mounted in a rear bumper, body panel, or where traditional lights would never fit.
Searches for the S2 Pro wide cornering flush mount, Baja Designs 487807 reverse light pods, and a universal flush mount LED pod pair for off-road trucks and UTVs usually lead to this exact kit. The included wiring harness is 120 inches long, which gives room to route the leads from the rear panel to the reverse circuit. The manufacturer says the kit includes what is needed for a quick install. Plan the cutout before you drill, and check the manufacturer's installation resources for the required hole size and panel thickness, since the published figures we found vary.
Yes. The manufacturer lists a wiring harness with a 120-inch length as included with this pair.
The manufacturer's spec lists 2,245 raw lumens per light at 1.7 amps. Some published materials cite 2,450 lumens, so details vary. Confirm the figure with the manufacturer before relying on it.
Because this is a universal flush-mount design, there is no vehicle-specific bracket to match, but you must cut a clean, accurately sized hole for each pod. Before drilling, confirm the hole diameter and maximum panel thickness with the manufacturer's installation resources, as the figures we found were inconsistent. Route the 120-inch harness from each light to the reverse circuit, and use the stainless hardware included with the kit to secure each pod.
