The Baja Designs 610015 is a 3 ft wire hider strip sold as a kit for auxiliary light wiring. The manufacturer says the kit lets owners run wiring without it being visible on the windshield or roof, and it avoids tucking harness into tight spots or drilling into the vehicle. Buyers who want a clean, factory-looking light install without body modifications get the most value from it, and it costs less than a custom routing job.
Owners on the manufacturer's review section describe the finished look as clean, and one reviewer noted little wind noise after installation. Because the strip is adhesive-mounted, it suits a quick wire hider install on a windshield header or roof rail where a wire harness would otherwise dangle. The 3 ft length covers a single run, so buyers planning a longer route, such as a 9 ft wire hider kit for a full light bar run, should consider the separate 9 ft kit. Search terms this part matches include "3 ft wire hider windshield," "hide light bar wiring without drilling," and "Baja Designs 610015 wire hider kit."
The manufacturer lists the 9 ft setup as one 9 ft wire hider strip, six 3M adhesive tape sheets, and three rubber promoter pens. The 3 ft kit (610015) includes one 3 ft strip, two adhesive sheets, and one rubber promoter pen.
The manufacturer names this product line "Wire Hider Kits - Universal," so it is not built for a particular make or model. Measure your planned wiring route before ordering to confirm that 3 ft is enough.
Owners who reviewed it on the manufacturer's site describe the fit and directions as easy to follow. Follow the manufacturer's installation sheet for the specific steps.
The manufacturer publishes an installation sheet for the 610015 kit, and owners have described the directions as clear. Before peeling any adhesive backing, lay the strip along the planned route and mark the start and end points. Use the rubber promoter pen included in the kit as the installation sheet directs, and press the 3M tape firmly for the full contact time. Because the adhesive is permanent once set, a dry run first prevents misaligned runs.
