The Dinan D760-0045 is a carbon fiber cold air intake for the F80 BMW M3, and the same kit covers the F82/F83 M4 and F87 M2 Competition. It swaps the factory airbox setup for dual enlarged, sealed airboxes, which the manufacturer describes as about 20% larger in volume. Air travels through an optimized carbon tube into a filter that is 30% larger than stock. A larger MAF housing is included, so the kit can be tuned to match its airflow.
The purchase case rests on three points: a sealed airbox that keeps engine-bay heat out of the intake charge, a sportier induction note, and a bolt-on install. Dinan claims up to 14 HP at 6000 RPM and 21 lb-ft at 3000 RPM, but only when paired with its Stage 2 tuning and exhaust. Owners on user forums report gains closer to 5 HP and 5 lb-ft without a tune, so buyers wanting real output should plan on a tune. The install is a DIY-friendly job. The manufacturer's instruction sheet calls for a T20 Torx driver to move the MAF sensor and a test fit of the carbon lid, and it notes that BMW recommends replacing the carbon brace.
The manufacturer's install sheet lists the F80 M3 Sedan for 2015-2018. Details vary across sources, so confirm the model year with the manufacturer before ordering.
The manufacturer ties its 14 HP and 21 lb-ft figures to tuning. Owners on user forums report much smaller gains without a tune.
Owners on user forums report that the MAF sensor can rub the carbon strut brace and that some aftermarket charge pipes do not clear the intake well. Test fit the MAF and pipes before final tightening.
Owners on user forums describe this as a straightforward bolt-on, with one reporting about 45 minutes to an hour and no special tools needed. The manufacturer's instructions have you remove each intake from its accordion boot, move the MAF sensors with a T20 Torx driver, insert the spacers into the carbon lid, and test fit the lid on the lower airbox so the filter does not interfere. Plan to replace the carbon strut brace, as BMW recommends, and recheck the MAF clearance against the brace and any aftermarket charge pipes.