The Dinan D760-0028 is a carbon fiber high flow intake for the E9x-generation BMW M3 V8, built around a carbon connecting tube and an injection-molded divider plate. Rather than replacing the whole airbox, it reuses the factory housing, and owners on user forums confirm that the stock air box is used as part of the design. The kit's listed components are the air filter with clamp, two intake hoses, an air filter tube, a carbon tube, and a hardware kit.
Owners weighing this against cheaper options point to the filter as the clearest upgrade. The Dinan-specific filter is bigger overall, with a larger surface area and more pleats than the stock filter. One owner who tried a BMC drop-in filter and a Stage 2 setup before settling on this kit called it the best intake option for our M3. Expect modest horsepower on paper: a forum dyno comparison suggested the gain was small, and the upgrade is mostly a matter of feel and sound.
The manufacturer's install sheet lists fitment for 2008-11 M3 E90 and 2008-13 M3 E92/E93 models. Confirm your VIN against the manufacturer's fitment list before ordering.
Yes. The manufacturer's steps remove the airbox lid and the stock intake tract, and owners on user forums report that the closed factory airbox stays in place as part of the design.
Details vary. The horsepower figure the manufacturer publishes was not confirmed on its own site during research, and owners on user forums describe modest gains. Confirm current published figures with the manufacturer before relying on a number.
This is a moderate DIY job that needs a T25 Torx bit and basic hand tools. The manufacturer's steps begin by releasing the T25 Torx screws and removing the airbox lid, then disconnecting the flexible hose by squeezing the lock ring and detaching it from the intake duct. Next, loosen the hose clamp at the intake plenum and remove the stock intake tract and air filter. During assembly, the manufacturer says to remove the stock hex head bolt and install the supplied button-head bolt and washer. Make sure the DINAN lettering on both hoses faces upwards, and walk the bands around the rubber hoses as needed so the clamps seat evenly. Owners on user forums say the lid's front-left corner has to angle toward the fender to clear the duct, so it cannot simply be lifted straight up. They also advise seating the filter's spring-loaded post so the filter does not wobble, and not over-tightening the Torx bolts on the lid. One owner reported finishing in about an hour.