The Borla 140315 is an S-Type Cat-Back exhaust system for the 2009-2016 Audi B8 and B8.5 A4 with the 2.0L turbocharged four-cylinder. Its front pipe attaches to the factory flange, so the catalytic converter stays in its original position while the rest of the exhaust is replaced. The system uses 2.5-inch tubing that ends in dual oval 3.5 x 2.75-inch mirror-polished tips at the left rear. Every section is T-304 stainless steel, and the manufacturer says this grade is superior to 409-type knockoffs for long-term corrosion resistance. Mandrel bends and CNC-cut parts are used for flow and a precise fit.
Owners who want a deeper S-Type note without highway drone are the target buyer for this system. The manufacturer says the design delivers that sound without drone inside the cabin. Owners on user forums report that the note can become loud for passengers, and some have added reversion cones or perforated cones inside the mufflers to reduce volume. That is worth knowing before you buy, especially if you plan to drive with others regularly. Browse B8 A4 2.0T cat-back exhaust, Borla S-Type 140315 install, and T-304 stainless catback for B8.5 A4 searches to compare this system with other options.
No. The manufacturer's installation instructions have you attach the new front pipe to the factory flange using the original hardware, and the product is designed as a cat-back system, so the factory catalytic converter remains in place.
The manufacturer states the S-Type design delivers its sound with no drone inside the vehicle. Owners on user forums describe the system as loud for passengers at times, and some have added cones inside the mufflers to lower the volume.
The manufacturer's fitment listing is organized by model year, body style, engine, and drivetrain (2.0L, FWD or AWD, 4-door sedan) rather than by trim package. Compare your car's year, engine, and drivetrain against that listing, and confirm with the manufacturer if you are unsure before ordering.
The manufacturer's installation sheet for this part lists a bolt-on procedure that needs basic hand tools: a 3/8-inch ratchet, a 3-inch extension, a 10mm socket, a Torx socket, a pry bar, and penetrating spray lubricant. Start by soaking the hangers, rubber isolators, and bolts in lubricant, then free the factory muffler hangers from their isolators. Attach the new front pipe to the factory flange with the original hardware, set the clamp over the pipe, and seat the muffler hangers in the isolators, leaving the clamps loose until the system is aligned. Borla's installation sheets for related Audi systems warn against air impact tools, which can bend flanges and cause leaks, and recommend a hoist or hydraulic lift. Let the exhaust cool for at least an hour before you start, and check tip clearance and alignment before fully tightening the hardware.