The Borla 140307 is an S-Type cat-back exhaust for the 5.7L HEMI V8 in the Ram 1500, replacing the factory system from the catalytic converter rearward. The kit runs 3" pipe that splits into dual 2.5" outlets and finishes in a 5" tip with a truck single split rear exit. The tubing is T-304 stainless steel, and mandrel bends and CNC manufacturing are used to keep flow smooth and the fit accurate. Borla's stainless-steel S-Type is the stronger buy over stock: the manufacturer describes the tone as aggressive sound, and the 304 stainless build is paired with the brand's Million Mile Warranty, a durability claim that a stock steel system does not match.
If you are searching for a 2009-2018 Ram 1500 5.7 Hemi S-Type catback, a through-bumper split rear exit, or a bolt-on dual exhaust for a 4WD crew cab, this part is built for those keywords. Borla lists the part as fitting 2009 through 2024 Ram 1500 models, but the manufacturer's own category page limits the 2019-2024 listings to Ram Classic 1500 models, and its install sheet for this kit describes a crew cab short bed with a 140.5-inch wheelbase. Those details vary across Borla's materials, so confirm your exact body style and bed length with the manufacturer before ordering. Fitment also depends on the tip position: the system fits through factory bumper cut-outs, which have notches on the bottom.
The manufacturer describes the 5.7L HEMI cat-back as a direct bolt-on installation with a through-bumper tip exit, and its install sheet for this kit lists only hand tools and spray lubricant. Confirm against the install sheet for your specific body style before starting.
The manufacturer's product page lists 2009 through 2024 Ram 1500 models, while its category page notes that 2019-2024 fitment applies to Ram Classic 1500 models only. Because these listings differ, confirm the model year and cab configuration with the manufacturer before ordering.
This is a bolt-on job, but the manufacturer's Ram 1500 5.7L guidance recommends an exhaust shop or professional installer. For the 140307, the install sheet lists a 3/8-inch ratchet, a 3-inch extension, a 10mm socket, a Torx socket, a pry bar, and spray lubricant. Let the exhaust cool for at least an hour before working on it, and wear eye protection. The manufacturer also recommends a hoist or hydraulic lift for the job. Keep the factory metal gasket where the guide calls for it, and use spray lubricant on the hangers and rubber isolators to ease removal.