The Borla 140707 is an S-Type cat-back exhaust for the 2009-2014 Dodge Challenger R/T with the 5.7L Hemi V8. The manufacturer describes it as a 2.5-inch system with a Merge X-Pipe and dual 4" x 2.5" polished T-304 stainless tips that exit through a dual split rear configuration. Borla says it delivers the classic S-Type sound without the cabin drone that many aftermarket systems produce on the highway. The system is made from T-304 austenitic stainless, which Borla contrasts with lower-grade 409 alloys, and it is covered by Borla's Million-Mile Warranty. For a buyer weighing this against cheaper cat-backs, that combination of a crossover-equipped flow path, corrosion-resistant construction, and a long warranty is what separates it from budget kits.
Fitment is limited to 2009-2014 Challenger R/T coupes with the 5.7L engine, in either automatic or manual transmission and rear-wheel drive trim. Owners on user forums describe a garage install that took roughly four hours with jack stands, and they note that the rear hangers must be transferred from the factory system and that the final clamps are hard to reach unless the front of the car is raised. Searches for 2009-2014 Challenger 5.7 Hemi cat-back, Borla S-Type 140707, 2.5 inch dual split rear exit, angle-cut tips, merge X-pipe, and T-304 stainless bolt-on exhaust tend to surface this exact configuration.
Yes. The manufacturer lists the system with dual 4" x 2.5" rectangular angle-cut polished T-304 stainless tips, so no separate tip purchase is needed.
Yes. The manufacturer states the system contains a Merge X-Pipe, which is intended to improve exhaust flow and sound.
No. The manufacturer lists the 140707 for the 5.7L V8 Challenger R/T only, so Scat Pack owners should look at the separate 6.4L part numbers in Borla's catalog.
This is a bolt-on cat-back, but it is not a quick job. Owners on user forums report that the factory clamps are typically removed with a 15mm deep socket, and that the rear hangers have to be moved from the stock system to the Borla pieces one at a time so each lands on its matching bracket. Jack stands under the mufflers help hold the weight while you reattach the hangers, and raising the front of the car makes the final clamps much easier to tighten. Plan for a full afternoon in a garage with four jack stands, and confirm the hanger hardware and clamps are included before starting.