Borla's Touring cat-back exhaust for 2009-2013 Chevrolet Silverado 1500 and GMC Sierra 1500 trucks replaces the factory exhaust with a 2.75-inch stainless run that ends in a single 4-inch polished tip on the passenger side. The manufacturer describes its pipes as T-304 stainless with mandrel bends and CNC-cut parts. The reason to pay more than for a budget cat-back is the tuning: Borla positions this Touring voicing as mellow, and owner reviews of Borla's Touring-style GM systems on user forums describe little cabin drone at highway speed. The manufacturer also backs its exhausts with a million-mile warranty.
Borla lists this system for 2009 through 2013 model-year trucks. Fitment must be verified by VIN, since sources disagree on hybrid and 2500HD coverage. Owners on user forums have reported that the side-exit tips can collect mud on off-road trucks, so a splash guard helps. For the do-it-yourself installer, Borla's install sheets for related Silverado cat-backs call for at least two people, because one person working alone risks injury. Let the exhaust cool for at least an hour before you start, and recheck the clamps after the first few hundred miles, since an owner on a user forum reported a loosened clamp that let the pipe contact the frame. Searchers looking for a 2009-2013 Silverado 1500 side exit Touring cat-back, a 2.75 inch Borla 4.8 5.3 6.0 V8 exhaust, or a Sierra 1500 Touring cat-back install are looking for this part.
The manufacturer specifies a single passenger side exit with a 4-inch tip, not a dual rear or split side setup.
Fitment details vary across sources, so confirm hybrid and 2500HD coverage with the manufacturer, and verify by VIN before ordering.
No. The manufacturer's install guidance for related Silverado cat-back systems advises two people and warns against one-person installs because of injury risk.
The manufacturer's install sheet for a related 6.2L Silverado cat-back lists a 3/8" drive ratchet, a 3/8" extension, a 15mm deep-well socket, a 13mm socket, a 10mm socket, a pry bar, and spray lubricant. Start by removing the left tailpipe hanger, then the left tailpipe at the differential flange, then the muffler assembly, and finally the front pipe clamp. Use a muffler stand or a helper to lower the assembly. Expect the work to be a moderate job: rust-stiff hardware and hangers are the usual frustrations, so soak fasteners beforehand. Keep the original clamps and hardware for reference, and recheck clamp tightness after the first few hundred miles. Confirm the exact steps for PN 140343 against the manufacturer's installation PDF before you begin.