The Borla 140200 is a Touring-series cat-back exhaust for the 2007–2009 Toyota FJ Cruiser 4.0L V6. This 2.25" diameter into dual 2" Cat-Back™ system delivers the mellow Touring sound with no drone inside the vehicle. The tips are single 4" round polished T-304 stainless steel pieces, one per tail pipe. Borla says its patented straight-through and multi-core technology is meant to free up power, and its T-304 austenitic stainless steel is chosen over cheaper 409-grade knockoffs for durability. Mandrel-bent tubing and CNC-built parts are meant to ensure maximum flow & power and an accurate fit, which matters when you are paying for a system rather than a generic universal pipe. This is a sound-focused upgrade for daily driving, highway cruising, and off-road-adjacent FJ owners who want a quieter tone than a loud-tuned setup.
Fitment is the first thing to confirm. Borla lists this part for 2007-2009 Toyota FJ Cruiser 4.0L V6 Automatic/ Manual Transmission 2 & 4WD 4 Door models only. Later FJs use different Borla part numbers, such as the 2010–2014 systems, so a 140200 will not bolt up to those years. The layout is a 2.25-inch single pipe that splits into dual 2-inch outlets, finishing in a Truck Single Split Rear Exit configuration. Searchers looking for a 2007–2009 FJ Cruiser 4.0 cat-back, a 140200 touring exhaust, or a T-304 split rear exit system will find the key details here. For installation, the manufacturer's install sheet for this platform says equipment, tools and experienced personnel needed for proper installation are important, and it recommends a hoist or hydraulic lift. Plan on a shop install unless you have a lift and exhaust experience.
The manufacturer lists part 140200 for 2007–2009 FJ Cruisers only. Borla sells separate cat-back systems for the 2010–2014 model years under different part numbers, so check the application before ordering.
The manufacturer describes the system as a bolt-on design that reuses the factory hardware and includes the pieces needed for installation. Owners on user forums have reported that some Borla FJ installs needed fitment adjustments, including hanger alignment and clearance around the tow hook, so budget time for a careful fit check.
Borla recommends that an exhaust shop or professional installer handle this job, and the manufacturer's install guidance calls for a hoist or hydraulic lift and extreme caution. If you proceed on your own, a penetrating spray lubricant should be applied liberally to all exhaust fasteners, especially on a used vehicle, and given time to work before you start removing bolts. Borla's install sheet for the related 2010–2014 FJ system lists a 3/8" drive ratchet and extension, 14mm and 15mm sockets, a pry bar, and spray lubricant as the minimum tool set. Use the hardware that comes in the kit, and check clearance from the body, brake lines, and tires before starting the engine.