The Borla 140169 is an S-Type cat-back exhaust for the NC-generation MX-5 Miata with the 2.0L four-cylinder, covering 2006 through 2015. Its 2.5-inch pipe steps down to dual 2.25-inch sections and ends in polished 3.2-inch round tips at a split rear exit. The manufacturer builds it from T-304 stainless steel with mandrel bends and CNC-cut parts, and it contrasts this grade against cheaper T-409-type knockoff pipe for longevity.
Compared with the factory system, this kit trades a quieter stock tone for an aggressive S-Type note that owners on user forums describe as deeper at low rpm, with a rasp at higher revs. The manufacturer says the design avoids cabin drone, but owners disagree. Some report almost no drone, while others say it hums at steady highway speeds, so confirm expectations with the manufacturer before buying. Stainless construction should also outlast aluminized alternatives in road-salt climates, which is the main reason to pay the premium over budget cat-backs.
This system is for the 2.0L NC Miata with either automatic or manual transmission in rear-wheel-drive, two-door form. Because it is a cat-back, it begins behind the factory catalytic converter. Owners on user forums report that the installation starts by cutting the midpipe ahead of the resonator, which removes the stock resonator and muffler, and that the job can be finished in roughly an hour with a reciprocating saw and the rear end raised on jack stands. Searches for an NC Miata 2.0L cat-back, S-Type exhaust, or 140169 install usually point to these same details.
The manufacturer lists the system for 2006–2015 MX-5 Miata NC 2.0L models with either automatic or manual transmission, rear-wheel drive, two-door.
Owners on user forums report that the system replaces the stock resonator and muffler, and that the midpipe is cut ahead of the resonator to join the two pieces.
The manufacturer recommends an exhaust shop or professional installer. Owners on user forums describe doing the install themselves in about an hour, so a careful DIY installation is possible for those with the right tools.
Owner experiences vary. Some on user forums report very little drone, while others say it drones at steady highway cruising speeds. Details vary, so confirm with the manufacturer before purchase.
Owners on user forums rate the job as manageable for someone comfortable working under a car, but the manufacturer still recommends a professional installer. Plan for a cutting tool, jack stands, a helper for the heavy pieces, and a torque wrench for the clamp hardware. The Borla inlet is SAE-sized while the stock pipe is metric, so the midpipe slides over the cut stock section and is held by the clamp that comes with the kit. Owners warn that under-tightened clamp nuts can leak, so torque them to the manufacturer's specification. Mind the hanger alignment and check for leaks before driving.