EBC 3GD Series Sport rotor for the Nissan Frontier, GD7404, listed as a rear slotted and dimpled rotor sold as a pair, built for the 2.5-liter, two-wheel-drive Frontier. The wide aperture slots are meant to pull air across the friction surface, which helps limit heat-driven fade under repeated stops. The model is listed for the D40 Frontier with the QR25DE 2.5L engine, from 2005 onward. Search terms: EBC GD7404 rear rotors, 2005 Frontier 2.5 2WD sport rotor, QR25DE slotted rear rotor.
Compared with a basic replacement rotor, the dimpled design avoids the through-holes that can develop stress cracks. Slotted rotors keep pads flat and wear them evenly, avoiding the grooving and galling common with plain rotors. The reduced three-slot venting produces less air noise under heavy braking while keeping the cooling benefit of a full-width slot. For a truck that tows or hauls, that mix of heat management and steady pad contact justifies the premium over stock.
Rear installation is mostly a caliper-and-hub job, and the parking brake is the usual snag. Owners on user forums advise releasing the parking brake first, since steel tabs on the parking brake shoes can grip the rotor hat. If the rotor will not come off, owners back the shoes away using the adjuster reached through the rubber plug in the rotor, and tap the hub near the studs (not on them) with a hammer after soaking it in penetrating oil. Plan on a 14mm socket and a 17mm wrench for the caliper bolts, plus a C-clamp to retract the piston over the new pads and rotor.
Owners on user forums report the rotor can bind against the parking brake shoes. Backing off the shoes through the adjuster accessed via the rubber plug in the rotor is a commonly described fix.
Owners on user forums suggest penetrating oil around the center hub and studs, then light hammer taps near the studs, with some adding heat if it still will not release.
Owners on user forums say a C-clamp is used to push the caliper piston back far enough to fit over the new pads and rotor.
Owners on user forums describe rear rotor replacement on the Frontier as a manageable DIY job with basic hand tools. Release the parking brake before removing the rotor, use penetrating oil on the hub and studs, and keep the caliper hanging so the brake hose carries no weight. Tools: 14mm socket, 17mm wrench, C-clamp, flathead screwdriver for the adjuster, and a hammer.