The EBC GD7087 is a front rotor from the manufacturer's GD Sport line, a slotted and dimpled design for the 2001-2003 Acura CL 3.2. Instead of through-drilled holes, the dimples let brake pads shed gas while avoiding the stress cracks the manufacturer associates with drilled discs. The wide slots pull cooler air across the pad contact area to limit fade during repeated hard stops, and the current generation carries a silver anti-corrosion coating.
Plain replacement rotors cost less, so the reason to pay more is the slotting and dimpling. A buyer who mainly commutes may be better served by a non-slotted disc, but anyone pushing the CL's 3.2 V6 through spirited canyon runs, track sessions, or heavy braking gets the cooling and debris-clearing benefit. Keywords to match: 2001-2003 Acura CL 3.2 slotted front rotors, EBC GD Sport front rotor upgrade, dimpled slotted brake rotor, CL 3.2 fade resistant front brakes.
Front rotor replacement on this car is a per-corner job: remove the wheel, the caliper and its bracket, then the old disc. Owners on user forums report that the rotor's retaining screws can hold the new disc in place while the caliper goes back on, and that corroded caliper ears are worth cleaning before reassembly. Pads should be replaced alongside the rotors so the new surfaces bed in evenly.
The manufacturer states that dimples allow pads to degas without through-drilled holes, which it links to rotor cracking. The wide aperture slots are a separate feature that helps cooling and clears dust and debris from the pad interface.
Owners on user forums report about 36 ft-lb for the front caliper bolts, with the caliper bracket-to-spindle bolts at 80 ft-lb. Confirm both figures against a factory service manual before torquing.
Owners on user forums report 80 ft-lb for the lug nuts. Tighten in a star pattern with a torque wrench.
Expect a standard front brake job: loosen the lugs, raise the car safely, and remove the caliper and bracket before pulling the old rotor. Owners on user forums suggest using the rotor retaining screws to hold the disc while refitting the caliper, and cleaning the caliper ears if they show corrosion. Keep a torque wrench on hand for the caliper bolts and lug nuts. If you open the hydraulic line, bleed the brakes afterward. The manufacturer's installation instructions were not located during research, so confirm procedure and torque values with the manufacturer or a service manual.