The Power Stop K1233 is a front brake upgrade kit for the 1995-2002 Toyota 4Runner, built on the manufacturer's Z23 Evolution Sport line. It pairs carbon-fiber reinforced ceramic pads with cross-drilled and slotted rotors, so you get a matched pad-and-rotor set in one box. The manufacturer describes the rotors as silver zinc plated for rust protection, with beveled drill holes that aid cooling under hard braking and rounded slots that keep the contact patch clear of gas and debris.
Compared with stock parts, the appeal is fade-resistant braking and less wheel dust. Compared with a cheaper pad-only swap, you also get premium stainless-steel hardware and a pin bushing kit, which means fewer parts to source during the job. The manufacturer backs the kit with a 36-month or 36,000-mile limited warranty that covers defects and rotor cracking, though it excludes normal wear, disc thickness variation, damage from non-approved DOT 5 silicone fluid, and over-tightened bleeder holes. Confirm your trim and model year before ordering, since fitment details can vary.
Front pad changes are the straightforward part of this job, while rotor replacement requires removing the caliper, and rust at the hub can make the rotor stubborn. For a 1995-2002 4Runner front brake kit, Z23 ceramic pad upgrade, or drilled and slotted rotor swap, this kit covers the full front axle in one purchase.
Fitment details can differ by trim and model year, so the manufacturer should confirm compatibility against your specific vehicle before you order.
The standard K1233 kit includes pads, rotors, and hardware. The manufacturer also offers a separate Z23 Evolution Sport version that adds powder-coated calipers.
The manufacturer's limited warranty runs 36 months or 36,000 miles from purchase, whichever comes first, and includes rotor cracking. It does not cover normal wear, disc thickness variation (usually indicated by brake pulsation), failures caused by non-approved DOT 5 silicone brake fluid, or stripped bleeder and banjo bolt holes from over-tightening.
Owners on user forums generally describe front pad changes as simple, with the wheel removal taking more time than the pads themselves. Rotor replacement means unbolting the caliper from the spindle and hanging it aside without letting it dangle from the brake hose. Forum members recommend loosening the brake fluid reservoir cap before pushing the pistons back, using anti-squeak compound only on metal contact points and never on the pad friction faces, and cleaning the new rotor with brake cleaner before installation. Penetrating spray helps when rust has bonded the rotor to the hub. Typical tools include 12mm and 17mm sockets, a C-clamp or piston press, caliper grease, and brake cleaner. Work on level ground, support the vehicle on jack stands, and follow the manufacturer's installation guide, including its break-in procedure.