This Power Stop Z36 Truck & Tow kit pairs carbon-fiber ceramic brake pads with drilled and slotted rotors, and the KC-prefixed version adds calipers. The pads are reinforced with carbon fiber to provide severe-duty stopping power, and the drilled and slotted rotors keep brake temperatures down by maximizing heat dissipation, which matters on long grades. Compared with worn stock pads and blank rotors, the kit is built for owners who tow trailers, haul loads, or run lifted 4x4s. The included hardware is premium stainless-steel, so the swap stays a straightforward bolt-on job. Searchers looking for a 1994-1996 Bronco front brake upgrade, Z36 carbon ceramic pads, or drilled and slotted towing rotors will find this kit matches those needs.
Fitment is listed for the 1994-1996 Ford Bronco and F-150, but the exact model years vary by trim, so confirm your truck's trim and axle before ordering. Owners on user forums note that front pad and rotor replacement on these trucks is a familiar job, but the caliper slides can seize, so clean and lubricate them during the swap. Plan on five moderate stops from 35 mph to 5 mph in rapid succession to bed in the new pads, and never cool your brakes with water. For a buyer weighing this against a cheaper pad-only swap, the rotor and caliper package is what delivers a complete front brake refresh rather than just a compound change.
Fitment is listed by trim, and listings differ on which years apply to certain trims such as the XL, XLT, Eddie Bauer, and XLT Sport. Confirm your exact year and trim with the manufacturer before ordering.
Yes. The manufacturer calls the break-in critical to performance, because it lays an even layer of friction material on the rotors. Follow its bedding procedure with moderate stops and let the brakes cool without water.
Owners on user forums describe the front caliper as held by two bolts behind it, and they advise setting the caliper on the radius arm or upper coil mount rather than letting it hang from the hose. Pushing the piston back requires a C-clamp, and some owners use the old pad as a backing plate for the clamp. Expect brake fluid to spill during this step, so keep rags handy. Owners on user forums also note that caliper slides can stick, so clean and lubricate them during the job. One owner notes that earlier models used pins rather than bolts on the caliper, so check your setup before you start. A jack, jack stands, a socket set, and a C-clamp cover most of the tools you will need.