The Power Stop KC6562-36 is a complete rear brake upgrade from the manufacturer's Z36 Truck & Tow line, combining rear rotors, carbon-fiber ceramic pads, and red powder-coated calipers in one bolt-on package. The pads use a ceramic compound reinforced with carbon fiber, and the manufacturer engineers them for heavy-load stopping while keeping daily driving manageable. For an Escalade that tows a boat or trailer on weekends, that balance is the reason to choose this kit over a pad-only swap.
The rotors are drilled and slotted, which the manufacturer says keeps brake temperatures down by improving heat dissipation on long mountain descents. The calipers are assembled and tested at the manufacturer's Chicago facility, and the powder coating is meant to resist rust and corrosion. Owners on user forums who tow heavy trailers also stress that a trailer brake controller and braked trailer matter as much as the tow vehicle's brakes, so this kit works best as part of a complete towing setup. Searching for a Z36 rear brake kit for the 2015-2019 Escalade, a red caliper towing upgrade, or drilled rear rotors for Escalade towing will lead you to this exact part.
The manufacturer sells this as a complete pad, rotor and caliper kit that includes premium stainless-steel hardware for a bolt-on installation.
Owners on user forums who installed this Z36 kit on other trucks advise having a piston compressor on hand and rotating the rear pistons as you compress them, since they can resist a straight push.
The manufacturer states that following the proper pad bedding procedure is critical for optimal performance, and that proper bedding can prevent rotor warping.
This is a moderate-difficulty job for a home mechanic comfortable with disc brake work and a piston compressor. Owners on user forums who did the same Z36 swap on another full-size truck reported about 90 minutes per corner, much of it spent cleaning rust from the hub face and clearing debris from the calipers. Clean the hub mounting surface thoroughly before setting the new rotors, since runout is a common cause of pulsation, and follow the manufacturer's bedding procedure afterward to protect the new rotors.