The Power Stop K103 is a rear-axle kit from the brand's Z23 Evolution Sport line. It pairs ceramic front/rear brake pads with drilled & slotted zinc rotors, aimed at owners of 2003-2005 Infiniti G35 models who want more from their rear brakes than stock hardware offers. Forum owners of these cars often report that early rotors warped at 28K miles, so a drilled-and-slotted rotor that vents heat and clears debris is a practical reason to pay more than for plain replacements. Forum discussions also note that stopping ability lacks the initial bite of some aftermarket pads, which is a trade-off worth weighing against the quieter, lower-dust behavior many owners want.
Fitment is the first thing to verify. The 03-04 brakes are smaller and different from later G35s, according to forum regulars, so match your front caliper type and model year before ordering. Because listings disagree on which front-caliper configurations this rear kit covers, confirm compatibility with the manufacturer using your VIN. Plan for a standard rear disc job: always use jack stands and never rely on a hydraulic jack alone, and expect a bench-clean, greased hardware install. Look for the manufacturer's break-in sheet in the box, since resin odor is normal as the brakes heat up during the first stops.
Fitment depends on the front caliper type and model year. User forums report that 2003-04 G35 brakes differ from 2005 models, so the manufacturer should confirm compatibility by VIN before you order.
Yes. The manufacturer's Z23 guidance calls for a controlled break-in and notes that a resin odor is expected as the brakes heat up. Step counts vary between Power Stop kits, so follow the sheet included with your K103 kit.
User forums describe early rotor scoring and warping on 2003-2005 G35s, with some owners replacing or resurfacing rotors within the first 30,000 miles. Keeping brake fluid fresh and bedding the new pads properly are common owner recommendations.
This is a moderate-skill rear brake job. The manufacturer's general Z23 install sheet lists a car jack, jack stands, brake pad grease, a C-clamp for retracting the caliper piston, and DOT 3 or DOT 4 brake fluid as recommended by your owner's manual. Work on one side at a time so the opposite side serves as a reference, and set the rotor or wheel aside safely if the caliper must be lifted. Common gotchas include seized caliper slide pins, which should be cleaned and greased, and failing to bed in the pads afterward. Confirm the fitment and any parking brake considerations for your specific rear caliper configuration before starting.