The K3140 is the front-axle pad-and-rotor package from PowerStop's Z23 Evolution Sport line, sized for the bolt-on, no-modification fit on the 2003-2005 Infiniti G35 front brakes. Its pads use a carbon-fiber ceramic compound, and the manufacturer says its low-dust formula is verified through 3rd party on-vehicle testing. The rotors are drilled and slotted and zinc plated for rust resistance, and the kit adds dual-layer rubberized shims and stainless hardware. Against stock parts or budget pads, the case for this kit is a matched pad-and-rotor system from one manufacturer, backed by the 36 month / 36,000 miles Warranty listed for the Z23 line. Searchers looking for a 2003-2005 G35 front drilled slotted rotor upgrade, low-dust carbon ceramic pads, or a Z23 K3140 install will find those details covered here.
For a DIY owner, the front job is a manageable weekend task. Forum members who have done G35 brake work describe pulling the caliper with a 22mm socket for the front calipers, and loosening the lug nuts with a 21mm socket is the first step. Rotors can bond to the hub, so owners often reach for a dead blow hammer, and some rotors have a threaded hole that lets a bolt push the rotor off the hub. Check the caliper bracket hardware, pistons, and pad fit before torquing everything down, and keep the caliper supported so the brake line is not carrying its weight. Owners report about 2 hours for a complete front and rear pad and rotor swap, so a front-only job should take less time.
The manufacturer offers a separate Z23 Evolution Sport version with powder-coated calipers, which is a different package. The pad-and-rotor K3140 is the non-caliper kit, so check the listing title and part number before ordering.
The manufacturer describes the pads as having a low-dust formula that it says was verified through third-party on-vehicle testing. Actual dust levels will still depend on driving habits and wheel finish.
This is a moderate, beginner-friendly front brake job. You will need a 21mm lug socket, a 22mm socket for the caliper bracket bolts, a jack and jack stands, a C-clamp or D-clamp to compress the pistons, a dead blow hammer, brake cleaner, and needle-nose pliers for the pad clips. Keep grease off the rotor faces and the friction surfaces of the pads, since owners warn that contamination can ruin pads before they bed in. Lightly lubricating the back of the pads with a non-contaminating compound is a common owner practice, but the manufacturer's hi-temp lubricant is meant for the caliper slide pins. After reassembly, pump the brake pedal several times before driving so the pads seat against the rotors.