The Power Stop CRK6940 is a front brake kit for the 2016 Acura ILX, built on the brand's Z17 Evolution platform. The kit includes brake pads, rotors, and stainless-steel hardware, so the front axle gets a matched set rather than mixed parts. Brake rotors are fully coated, including inside the vanes, which the manufacturer positions as protection against rust while keeping a new-car look behind open wheels. Compared with stock rotors or a pad-only swap, this is a 2016 ILX front brake upgrade that addresses rust and wheel dust together.
The Z17 Clean Ride ceramic pads use a low-dust compound that was validated through on-vehicle 3rd party tests in USA, and the pads add dual-layer temperature-resistant rubberized shims to insulate noise for virtually silent braking. Each kit ships with the stainless steel hardware and high-temperature ceramic lubricant needed for a front brake job on a Geomet-coated, Z17 ceramic setup. Owners searching for Geomet coated ILX rotors, low dust ceramic pads, or a Z17 Evolution front kit will find this to be a complete, bolt-on option.
The manufacturer states the kit includes Geomet coated rotors, Z17 Clean-Ride ceramic pads, installation hardware, and sensors where applicable.
The manufacturer's break-in procedure calls for 30 decelerations from 30 mph to 5 mph, with 30 seconds of cooling between each stop. Expect a resin smell as the brakes heat up, and avoid holding the pedal down while the rotors are hot, since that can imprint the rotor and contribute to judder.
Owners on user forums for Acura compact models advise keeping grease off the pad and rotor friction surfaces, cleaning the rotor with brake parts cleaner, and being ready for seized rotor retaining screws, which one owner reported on this platform.
This is a standard front pad and rotor replacement. The manufacturer's install guide lists brake fluid (per the owner's manual), brake component lube, and a caliper piston compressor or C-clamp as the core tools. Check the reservoir level before you start, and support the caliper with a hanger instead of letting it hang from the brake hose, since hose damage is a common mistake. Push the caliper piston back slowly and watch the reservoir so it does not overflow, because rapid compression can cause back pressure that damages the ABS modulator or master cylinder. Clean the new rotors thoroughly, keep grease off the friction surfaces, and complete the bedding procedure before normal driving.