The PowerStop CRK7942 is a complete rear brake kit for the JL-generation Jeep Wrangler. It pairs Z17 Evolution ceramic brake pads with rotors finished in genuine GEOMET coating. The manufacturer describes the coating as protection against rust and corrosion, and the kit includes stainless-steel hardware and high-temperature brake lubricant, so a rear brake refresh needs no separate parts.
Compared with worn stock rear hardware, a matched kit like this makes sense if you want low-dust, quieter rear braking without mixing pads and rotors from different brands. The manufacturer says the Z17 ceramic pads use a low-dust formula, and the coating is meant to keep the rotors looking clean behind open wheels for longer. Before ordering, confirm your model year and trim against your VIN, because the listed year ranges for this kit are not consistent across sources.
Plan on a bolt-on rear job that calls for a large C-clamp, brake fluid, and a torque wrench. Many rear pistons screw in and out, so a standard C-clamp may not retract them, and the manufacturer's install guide flags this. Bed in the coated rotors using the separate Evolution break-in procedure the manufacturer publishes, not the sequence for drilled and slotted rotors. Wrangler JL owners searching for a rear brake pad and rotor kit, GEOMET coated rotors, or a low-dust ceramic rear brake upgrade will find those details covered here.
Yes. The manufacturer says skipping a proper pad bedding can leave uneven pad material deposits that cause vibration and weaker braking, and it publishes a separate break-in procedure for Evolution coated rotors.
The manufacturer's install guide notes that many rear pistons cannot be retracted with a C-clamp because they screw in and out, so plan for a method suited to screw-type pistons.
Yes. The manufacturer states the kit includes stainless-steel installation hardware along with the pads and rotors.
This is a rear-axle job that a mechanically confident DIY owner can handle with basic hand tools, a large C-clamp, and a torque wrench. Per the manufacturer's install guide, you should open the bleeder screw to release fluid as you push the piston back, and then bleed the brakes to remove air from the line, starting with the master cylinder reservoir filled to the max line. Use the high-temperature lubricant on the pad backing plate edges where they slide in the caliper bracket, and use the supplied stainless-steel hardware, since the manufacturer warns that improper hardware can cause noise or poor pad performance. Torque the lug nuts to the manufacturer's specification, then complete the coated-rotor bedding procedure before heavy braking.