The Power Stop CRK7528 is a rear brake kit from the brand's Z17 Evolution line, pairing Z17 Clean Ride ceramic pads with Genuine Geomet fully coated rotors and stainless steel mounting hardware. The manufacturer says the coating is applied thinly, guards against rust and corrosion, and does not reduce braking performance. Because the coating extends inside the rotor vanes, it protects the areas that usually corrode first on a daily-driven CR-V. Compared with a pads-only swap or stock replacement rotors, the advantage is a matched package: the pads, rotors, hardware, and high-temperature lubricant are engineered as one system. The low-dust pad formula has been validated through third-party on-vehicle testing, and the dual-layer rubberized shims are designed to quiet squeal.
This kit is listed for the rear axle of the 2017 to 2018 Honda CR-V, but application data differs across sources by model year and trim, so confirm your exact vehicle against the manufacturer's fitment guide before ordering. Rear calipers on this generation use an electric parking brake motor. Owners on user forums report that the piston cannot simply be pushed back with a standard C-clamp, so plan for the parking brake retraction procedure before you start. Shoppers searching for CR-V rear Geomet rotors, Z17 ceramic pads, or a CRK7528 DIY install will find this kit covers the full rear job in one box.
The manufacturer states the kit includes stainless steel installation hardware and high temperature ceramic brake lubricant. Its instruction sheet also lists sensors where applicable, so confirm whether your vehicle requires one before installing.
Yes. The manufacturer recommends performing 30 decelerations from 30 mph to 5 mph, with 30 seconds of cooling between each stop. Expect a resin smell as the brakes heat up, and never cool the brakes with water. Proper pad bedding helps prevent rotor warping.
This is a moderate DIY job that most home mechanics with a floor jack, jack stands, torque wrench, and basic hand tools can complete. Owners on user forums note that the rear calipers use electric parking brake motors, which must be retracted before the pistons can be pushed back, and some owners use a scan tool maintenance mode to do this. Support the caliper with a hanger rather than letting it hang from the brake hose, keep grease off the pad friction surfaces and rotor faces, and clean the hub mating surface before mounting the new rotor. Torque the caliper bracket and slide pin bolts to the values in the factory service manual rather than relying on general specifications, then bleed the brakes and top off the fluid to the max line. Finish with the break-in procedure described above.