This Wilwood Combination Parking Brake (CPB) rear kit replaces rear hardware on Honda Civic and Acura Integra chassis with an 11.00-inch drilled and slotted two-piece rotor on aluminum hats, paired with a black powder-coat single-piston caliper. The caliper runs on hydraulic pressure from the master cylinder for service braking and carries an internal mechanical lock for the parking brake, so the handbrake works at the caliper itself. The kit includes BP-10 high-friction pads, which gives a noticeable step up from stock rear hardware for track days, autocross, and spirited street driving.
Choose this kit over stock when you want rear braking that matches a front big-brake upgrade in size and balance. It is a better fit than a rear pad-only swap when you need a larger rotor and a more substantial caliper for repeated stops. Check the 2.39-inch hub offset and the 15-inch minimum wheel diameter before ordering, since these determine whether your wheels clear. Long-tail searches for this setup include 11 inch rear CPB brake kit, Civic Integra drilled slotted rear rotor, 2.39 hub offset rear big brake kit, and Wilwood combination parking brake caliper conversion.
The manufacturer states that rear brake kits are not supplied with hydraulic lines or fittings, and that parking brake cables, hardware, and adapters are sold separately. For this kit, the manufacturer lists rear line kit 220-10840 and parking brake cable 330-10966 or 330-10993 as companion parts.
The manufacturer lists this kit for Acura and Honda vehicles and says it may fit other applications. It directs buyers to verify fitment on its website or call Wilwood tech support at (805) 388-1188 before ordering.
The manufacturer lists a 15-inch minimum wheel diameter for this kit.
This is a substantial rear brake and parking brake conversion, not a bolt-on pad swap. Wilwood's cable instructions for 1990-2002 Honda/Acura Civic and Integra describe raising and supporting the rear on jack stands, removing the center exhaust heat shield bolts, and removing one dust shield bolt to free the factory cables. Reaching the handbrake adjuster requires removing the rear ashtray and two console access panels. The manufacturer says the installer is responsible for routing cable away from exhaust and moving suspension, keeping bends at a minimum 6-inch radius, and securing housings with clamps that are not included. Use anti-seize on aluminum nuts. Plan for the hydraulic line kit before you start, because this kit does not include lines.