The Wilwood GP200 caliper (part 120-17702) is a two-piston, billet aluminum caliper with 1.25-inch pistons, built for thin 0.25-inch rotors in tight-fit racing setups. The body is CNC-machined with an FEA-generated design that reinforces the transition between the piston housings and bridges, which substantially increases resistance to deflection and body separation under load. Heavy-wall stainless pistons slow heat transfer from the pads and eliminate piston backside deflection at higher system pressures. Replaceable stainless SRS bridge plates protect the caliper body from pad-gouging wear, so the caliper lasts longer under race use. Fitment is tied to sprint and midget applications: Wilwood's GP200 System pairs the billet caliper with its Dynamic Rotor Mount system and Super Alloy rotors for fade-resistant performance. Because this is a bare caliper, the mounting bracket, rotor, and pads come separately, so plan your bracket and rotor selection before ordering. Search terms: GP200 sprint car caliper, 2-piston 1.25 bore 0.25 rotor, 2.38 lug mount caliper, Wilwood 120-17702 micro sprint brake.
The manufacturer lists this caliper as a stand-alone part and sells its mounting brackets separately. For example, bracket 250-18217 is listed for mounting a GP200 two-piston caliper on a sprint right-rear with a 10.50-inch rotor.
The manufacturer's installation instructions call for Wilwood Hi-Temp 570 grade fluid or EXP 600 Plus, with EXP 600 Plus recommended for sustained high-heat operation.
The manufacturer's sprint-kit instructions say installation should be performed by people experienced with disc brake systems. Check the rotor position through the top opening of the caliper; if the rotor is off-center, add or remove shims, using the same number on both mounting bolts. Remove the pad retainers, slide the pads in, and reinstall the retainers, making sure the pins are fully seated. Use steel braided lines with PTFE tape on the pipe threads at the caliper. When bleeding, begin with the caliper farthest from the master cylinder and bleed the outboard screw first, then the inboard. Bleed only from the top screws, keep the bottom screws tight, and check for leaks afterward. Tools needed: wrenches, shims, PTFE tape, a bleed bottle or vacuum bleeder, and a fresh bottle of racing brake fluid.