The Wilwood 120-13235 is the right-hand version of the Forged Superlite 6R radial-mount caliper, a six-piston design with Piston Count · 6, Piston Area (in²) · 4.04, Piston Type · Stainless. The body is forged aluminum, and the manufacturer lists its Weight(Lbs) · 5.4. For a track or autocross build, a forged body with a radial mount is a practical step up from a stock single- or two-piston caliper, because the larger pad area, Pad Area (in²) · 8.2, helps spread clamping force and resist fade under repeated hard stops.
Buyers searching for a 14-inch big brake upgrade will want to confirm the rotor match. The manufacturer lists a Rotor Width (in) · 1.25 and Rotor Diameter(in) · 14.00, so this caliper is aimed at 14-inch by 1.25-inch rotor setups. Pair it with a matching radial-mount bracket and pad set, and check that the handedness matches your hub side before you bolt anything up.
The manufacturer lists 120-13235 as the right-hand caliper, with 120-13236 Anodize Caliper Left Hand as the mirror-image part. Confirm the side before ordering.
The manufacturer specifies a 14.00-inch rotor diameter and a 1.25-inch rotor width for this caliper, so it is intended for 14-inch rotors of that thickness.
No. The manufacturer's listing shows Dust Boot · No, so keep the stainless pistons clean during pad changes and service.
Start by confirming the caliper is the right-hand part (120-13235) so it matches your mounting side, since the manufacturer also sells the left-hand 120-13236. Check that your rotors measure 14 inches in diameter and 1.25 inches thick. Because the caliper is a fixed six-piston unit with no piston dust boots, keep the pistons clean during pad service and bleed the system fully after installation. The install sheet and tool list were not confirmed during research, so check the manufacturer's instructions before starting.
