The Baja Designs 388001 is a single black rock guard for the S1 LED auxiliary light. It is made from hard-coated polycarbonate and mounts over the front of one S1 pod to take hits from rocks, mud, and flying trail debris before they reach the lens. The black finish carries the Baja Designs logo, so the cover also works as a styled piece while the light is off.
Leaving an S1 lens exposed on a trail invites scratches and cracks, and a guard gives you a replaceable barrier in front of the optic. The manufacturer notes that a damaged guard can be swapped out on its own, which keeps repairs cheaper for off-road riders, desert racers, and overlanders. Keep in mind that the black version is meant for protection only. The manufacturer says black rock guards cannot be used while the lights are on, so trail lighting calls for the amber or clear variants. Owners on user forums describe Baja rock guards as push-on, pull-off pieces, though snap engagement can feel different depending on where the light is mounted.
Check fitment before ordering. The manufacturer lists this guard for the S1 series and states it is not compatible with flush mount models, so confirm your pods are the standard surface-mount type. Installation is designed to be quick, and the guard can be removed for cleaning or maintenance. Enthusiasts searching for an S1 LED light rock guard, a black S1 pod lens cover, or a 388001 replacement guard will find this is the right part for that job.
No. The manufacturer states this guard is not compatible with flush mount models, so confirm your S1 pods are the surface-mount type before ordering.
No. The manufacturer says black rock guards cannot be used while the lights are on. The black version is for protection when the light is off, and the amber or clear versions are the options for lights-on use.
The manufacturer sells this guard individually, so buy one for each S1 light you want to protect.
The manufacturer says the guard is designed for quick installation and removal, which makes cleaning and replacing a damaged guard straightforward.
The manufacturer describes this guard as designed for quick installation and removal, so it is a tool-free style job in the sense that it snaps or presses onto the light rather than being bolted in. No official install sheet for this part was found, so confirm mounting steps with the manufacturer. Before you start, verify the pod is surface-mount rather than flush mount. Press the guard evenly over the front of the light until it sits snug, then check that the fit is secure before you hit the trail. Owners on user forums note that the seating feel can vary by mounting location, so check it on each light. Remember to swap to the amber or clear guard for lights-on use, since the black guard is for when the light is off.
