The Dinan Free Flow Axle-Back Exhaust with black tips is a 304 stainless steel rear exhaust for the B58 3.0L inline-six in the BMW M240i and M240i xDrive. It replaces the factory rear section and finishes with twin 89mm (3.5") laser-engraved ceramic black tips. Dinan removes the factory computer-controlled exhaust valve, so the system runs open at all times. Dinan rates the kit at +6 HP and +5 lb-ft at 6,600 RPM. The main reason to choose it over stock is the deeper tone and sharper upshift pops, with a modest power gain on top. Because the kit is built to the car's own mounting points, it is a better match for an F22 M240i sport exhaust than a generic universal muffler.
Drone is the usual trade-off with aftermarket M240i exhausts. Dinan says a Helmholtz chamber in this system reduces low-RPM resonance, which helps keep the cabin livable on daily drives. Owners on user forums report that drone is most noticeable at steady cruising speeds and depends on final-drive gearing, so real-world results vary. Buyers searching for an F22 M240i axleback, B58 drone-reduced exhaust, or a 3.5" black tip axle-back should also know the factory valve is gone, so there is no quieter valved mode.
No. The manufacturer states that the factory computer-controlled exhaust valve is eliminated with this system, so you will not have a valved quiet mode.
Sources differ on the year range, with some listings showing 2017–2019 and others 2017–2021 or 2016–2021. Confirm compatibility for your specific year and body style with the manufacturer before ordering.
The manufacturer says the Helmholtz chamber design reduces low-RPM drone. Owners on user forums report that drone can still show up at certain steady cruising speeds, depending on gearing, so expect the result to vary.
The manufacturer publishes installation instructions for this part number, and the kit is designed to mount on the factory hangers and brackets with included clamps and hardware. The manufacturer also advises replacing factory rubber hangers if they are worn, so inspect them before you start. Owners on user forums say that axle-back work on this chassis often means cutting the factory tailpipe section, so plan for a cut-and-clamp job rather than a pure bolt-off swap, and confirm the cut point in the instructions. Plan on a jack or lift, jack stands, and a basic socket set, along with a cutting tool if the instructions call for one.