Dinan's Free Flow axle-back is a rear-section replacement for the 2016–2018 BMW M2 (F87) with the N55 3.0L turbo six. The manufacturer describes it as 100% stainless steel, sized to mount on the factory hangers and mounting points. Its computer-controlled valve stays civil at low speed and opens fully under heavy load, and the stock valve actuators are reused. Owners on user forums say the Dinan muffler with the factory resonator sounds like a deeper, amplified version of stock, which suits buyers who want a cleaner note than a pops-and-burbles setup.
The real case for this part over a cheaper muffler or a full resonator-delete setup is drone control. Owners on user forums report that removing the resonator is what makes the car drone when the valve is open, while the factory-resonator configuration stays quiet for many. The manufacturer lists a gain of +6 hp and +5 lb-ft for this system. Searches for F87 M2 N55 axle-back exhaust, BMW M2 valve-controlled muffler, and M2 drone-free Dinan exhaust tend to surface the same tradeoff. Plan on a professional install if you lack a lift, since a forum owner who lacked a lift had a shop do the job.
Owners on user forums report that the Dinan muffler with the stock resonator produces little to no drone, while removing the resonator tends to introduce drone when the valve is open. Several owners say closing the valve during sustained cruising reduces it.
The manufacturer states that the computer-controlled valve remains in use, staying closed at low speed and opening fully under high load. The stock valve actuators are reused.
Per the manufacturer's install sheet for this part, the job starts with disconnecting the battery using BMW's factory procedure and disconnecting the valve actuator. Support the stock muffler on a jack or stands, and test-fit the Dinan muffler beneath the stock unit before cutting at the BMW dimple so the pipe is not cut too short. Save the hanger nuts, move both stock hangers onto the Dinan muffler, and secure the supplied valve harness with the included zip ties. Owners on user forums describe the job as needing a lift or proper stands and ramps, and one owner had a shop tack-weld the joints to reduce rattle. Confirm the tools and steps against the current manufacturer instructions before starting.