The aFe MagnumFORCE Spare Parts AIS Soft Parts for XX-80882 (MPN 59-80882) is a replacement soft-parts package for the MagnumFORCE cold air intake line, not a complete intake. The manufacturer sells this family of packages for existing intake systems whose part numbers end in the matching suffix, so the -80882 designation is the key compatibility check. Replacing worn couplings and clamps is usually a smaller outlay than replacing an entire intake assembly, and it lets you restore a sealed intake path without giving up the intake you already have.
For a track or street buyer searching for an aFe 59-80882 soft parts kit, MagnumFORCE 80882 intake hose replacement, or an aFe 51-80882 intake coupler and clamp refresh, the practical benefit is sealing and durability. aFe's standalone replacement worm gear clamp is corrosion-resistant stainless-steel construction provides long-lasting durability, which is the same level of hardware you should expect from a matched soft-parts package. Before ordering, confirm your intake's part number ends in 80882, since fitment follows the intake number rather than a vehicle list alone.
No. The manufacturer describes its MagnumFORCE packages as soft-part replacements for existing air intake systems that end with the matching number, not as complete intakes.
The manufacturer advises checking your cold air intake's instruction sheet to confirm the required hose size before replacing any hose.
The manufacturer's standalone replacement worm gear clamp can be tightened with a 5/16-inch socket or a flathead screwdriver. Confirm the clamp size for your specific intake before purchasing.
This is a moderate DIY job that mostly involves unbolting the factory intake, transferring sensor and vent hardware, and reseating the couplings and clamps. The manufacturer's install sheet for a comparable aFe intake calls for a Phillips screwdriver and an 8mm nut driver, and it starts by disconnecting the negative battery terminal. Expect to move the mass air flow sensor to the new tube, and when you reinstall it, use the gasket and M4 screws supplied with that intake, since sealing at the sensor is a common gotcha. Tighten the large housing clamp with a nut driver, and check the manufacturer's installation video on its YouTube channel for visual reference. Use the instruction sheet that ships with your specific kit, because steps vary between intake models.