The aFe MagnumFORCE Spare Parts AIS Soft Parts kit (59-80782) is a set of replacement couplings, clamps, and sensor seals for aFe's Magnum FORCE cold air intake systems, not a complete intake. The manufacturer describes it as a spare parts replacement kit for aFe POWER cold air intake systems. Renewing a cracked or hardened coupler is a far cheaper fix than replacing the whole system, and a split coupler lets unfiltered air bypass the filter or leak past the mass airflow sensor, which is the problem this kit solves for a buyer chasing consistent throttle response and boost.
The box holds a reducer coupling, a hump coupling, a resonator plug, and a foam gasket for the MAS airflow sensor. The reducer measures 4-3/8" x 3-1/2" ID by 2-3/4" long, and the hump coupling is 4" ID by 3" long, both in silicone. The manufacturer notes that the coupling hose allows for expansion, movement, and vibration, and the kit ships with standard stainless steel worm-gear clamps. The resonator plug is for builds that delete the inlet tube resonator: if no resonator is used, cap off the tube with the plug. Searchers looking for an XX-80782 soft parts kit, aFe 59-80782 coupler replacement, or MagnumFORCE MAF foam gasket will find this package addresses those needs. Confirm your intake's part number ends in 80782 before ordering.
The manufacturer describes this kit as a soft-part package for existing aFe intake systems whose part number ends in 80782. Confirm your intake's exact part number and vehicle application with the manufacturer before ordering.
Details vary. The manufacturer's listed contents are couplings, clamps, a resonator plug, and a MAS gasket, and no filter appears in that list. Confirm with the manufacturer before ordering if you need a filter.
Per the manufacturer, the resonator plug caps off the inlet tube when no resonator is used, so the tube is sealed rather than left open.
This is a basic hand-tool job: loosen the stainless worm-gear clamps, swap the silicone reducer and hump couplings, and reseat the new clamps. Check that the foam gasket seals fully around the MAS airflow sensor, since a poor seal there can cause air leaks and sensor errors. If you are removing the resonator, fit the plug into the inlet tube and tighten the clamp so no gap remains. Tighten clamps evenly and inspect the couplings for kinks before starting the engine.