The Eibach Pro-Spacer S90-4-25-051 is a 25mm pair of bolt-on wheel spacers from the manufacturer's Pro-Spacer line. The manufacturer describes them as precision-engineered and hub-centric, so the wheel centers on the spacer rather than relying on the lug nuts alone, which helps keep the wheel balanced at speed. One owner on a user forum reports running a set of these 25mm spacers above 150 mph with smooth behavior. Fitment needs care: the manufacturer's current application list shows 2010-2012 Camaro V6 and SS models and 2020-2024 Cadillac CT5 2.0T RWD, so confirm 2016-2017 Camaro V6, 2.0T, or SS fitment with the manufacturer before ordering. Search terms: Eibach 25mm spacers for 6th gen Camaro, hub-centric bolt-on spacers, Camaro wheel track widening kit, 5x120 spacer with stock studs.
Owners on user forums report that 25mm spacers generally fit without trimming the studs, while 20mm spacers often required trimming. Some owners did trim studs on their setups, so details vary and the wheel pocket should be measured before installation.
The manufacturer states that the spacers can only be used with wheels that have cut-outs facing the hub to clear the stock studs. Wheels without those cut-outs are not compatible.
The manufacturer gives an example of a 35mm stock stud minus a 25mm spacer, leaving 10mm of excess stud length. That excess must fit into the wheel's cut-out, which the manufacturer specifies as 11mm deep.
Installation involves the hub face, the spacer, and the wheel, and it is more involved than a typical bolt-on upgrade. Eibach's Pro-Spacer installation sheets for other systems call for cleaning the hub and wheel contact surfaces with a wire brush, checking the centering and bolt pattern, placing the spacer on the hub, and then mounting the wheel onto the spacer. Before mounting, measure your wheel's rear pocket depth against the 11mm cut-out specified for this kit, and confirm that the wheel has enough dish clearance for the stud tips. One owner on a user forum recommends Loctite Blue on the spacer mounting bolts. Confirm the torque specification with the manufacturer, since it was not found on the spec page.