Dinan's 10mm wheel spacer set is a matched pair sized for 5x120 BMW hubs with a 72.6mm center bore, so it pushes the wheel outboard for a flush stance or added room near the brake calipers. Because the manufacturer engineers these spacers for its own BMW fitments, they are meant to avoid the balance problems it associates with universal spacers. Owners on user forums often pick the 10mm thickness as a middle ground for E-chassis cars, though fit can vary by hub and wheel, so confirm with the manufacturer before ordering.
Choosing a Dinan-branded pair over a cheaper universal kit mainly buys predictable fitment and a finish that matches Dinan's BMW wheel line. The manufacturer's general application guide lists the E chassis at 5x120 with M12x1.5 lug bolts, and the F chassis at 5x120 with M14x1.25 bolts, with exceptions on some models such as the F9x and F48/F39 X1/X2 platforms. Buyers searching for "BMW E90 10mm 5x120 wheel spacers," "72.6mm hub-centric spacers," or "M12x1.5 extended wheel bolts" will want to verify their chassis before ordering, since bolt thread is the detail most likely to differ between platforms.
Yes. The manufacturer states that longer bolts are required when using wheel spacers and that they are sold separately. Owners on user forums typically take the stock bolt length, roughly 25mm on E90-era cars, and add the spacer thickness, which points to about 35mm for a 10mm spacer.
The manufacturer's application guide lists this 5x120 spacer under the E chassis, which uses M12x1.5 lug bolts. Confirm your exact model year and chassis with the manufacturer before installation, since the guide notes that exceptions exist.
This is a moderate DIY job that mainly requires a secure lift or jack stands, a torque wrench, and the correct extended lug bolts. The manufacturer's install sheets for other Dinan spacer kits warn against working on a vehicle supported only by a jack and call for keeping front and rear lug bolts separated, since they are different lengths. Place each spacer over the hub with the countersink facing the rotor, mount the wheel, and torque to the specification listed for your bolts. Verify tire-to-fender and strut clearance afterward, and recheck the lug torque after the first few hundred miles.