Part 80426 brings BAK's Revolver X4s design to the 2016-2023 Toyota Tacoma with a 5'1" bed. It rolls back for full bed access and locks closed to protect what you carry.
The X4s pairs interlocking aluminum slats with TriShield 70-grade vinyl for a roll-up that is both tough and tidy.
A Tacoma bed is built for gear. Covering it keeps that gear locked up and out of the weather without giving up access when you need it.
Slash resistant and locked by default. Patented rotational locking rails and automatic slam latches work with the aluminum slat design to resist prying, slicing and forced entry.
Sealed where it counts. Side seals fit flush against the cover and an integrated bulkhead seal closes off the front, while the nearly flush fit with the rails keeps the profile clean.
No seams on top. The surface is a single piece of aluminum-reinforced TriShield 70-grade vinyl over interlocking aluminum slats rated for 400 lb evenly distributed. The slats, clamps and hardware are matte black to match.
Quick to open. Roll the cover toward the cab with PrecisionRoll technology, strap it down with the integrated safety straps, and use the full bed with the rear window and factory cameras unobstructed.
Fit notes: It is not compatible with factory bed storage boxes. Also match the bed length shown in the fitment line above.
With a five-year limited warranty behind it, the BAK 80426 is a secure, full-access roll-up for your truck. Order it from Track Ready Products and match the bed length above before checkout.
Expect to be done in under an hour. The Revolver clamps to the bed rails with the included kit, so there is no drilling.
Start with a clean set of rails. Position the cover, tighten the clamps evenly, and run it through a full open and close cycle to check that it moves freely and latches.
Recheck the clamps after about a week, wash with mild automotive soap and water, and clear off snow and ice before opening. Keep the cover secured at all points whenever you drive.
