80331 is the BAK Revolver X4s Hard Roll-Up Tonneau Cover sized for the 2017-2026 Ford F-250, F-350 and F-450 with an 8' bed. It rolls back for full bed access and locks closed to protect what you carry.
It builds on the Revolver platform with upgraded materials, better weather protection and an all-matte black finish.
On a Super Duty the bed is a rolling toolbox, and a hard cover keeps what is in it protected from weather and out of sight.
100% bed access. PrecisionRoll technology rolls the cover up toward the cab, integrated safety straps hold it rolled, and the open cover does not block the rear window or factory cameras, so you can drive with the bed open.
Slash resistant and locked by default. Patented rotational locking rails and automatic slam latches work with the aluminum slat design to resist prying, slicing and forced entry.
Low profile, tight seals. The cover sits nearly flush with the bed rails, and flush-fitting side seals plus an integrated bulkhead seal help keep water and dust out of the bed.
Aluminum slats under one-piece vinyl. Patented interlocking aluminum slats sit beneath a seamless, aluminum-reinforced TriShield 70-grade vinyl surface with a matte finish that resists dust and stains. The slats support up to 400 lb of evenly distributed weight.
If you want a hard cover that rolls out of the way instead of folding, the BAK 80331 is built for that job, with Level-3 security and a five-year limited warranty. It is available from Track Ready Products.
Expect to be done in under an hour. The Revolver clamps to the bed rails with the included kit, so there is no drilling.
Clean the bed rail caps first so the seals sit on a clean surface, set the cover in place, and tighten the clamps evenly from side to side. Work the cover open and closed once before you load the bed.
Recheck the clamps after about a week, wash with mild automotive soap and water, and clear off snow and ice before opening. Keep the cover secured at all points whenever you drive.
