Looking for a hard tonneau cover for your 2015-2020 Ford F-150 and 2017-2020 F-150 Raptor with a 5'7" bed? The BAK Revolver X4s Hard Roll-Up Tonneau Cover, part number 80329, is cut for that application. It is a hard roll-up, so the bed opens by rolling the cover toward the cab instead of folding panels.
The X4s pairs interlocking aluminum slats with TriShield 70-grade vinyl for a roll-up that is both tough and tidy.
The F-150 bed does a lot of different jobs. A hard cover protects the cargo on the way, and opens fully for the jobs that need the space.
Sealed where it counts. Side seals fit flush against the cover and an integrated bulkhead seal closes off the front, while the nearly flush fit with the rails keeps the profile clean.
No seams on top. The surface is a single piece of aluminum-reinforced TriShield 70-grade vinyl over interlocking aluminum slats rated for 400 lb evenly distributed. The slats, clamps and hardware are matte black to match.
Roll it back and the whole bed is yours. Safety straps secure the rolled cover, and it stays clear of the rear window and factory cameras while you drive. There are no panels to prop up or stow.
Slash resistant and locked by default. Patented rotational locking rails and automatic slam latches work with the aluminum slat design to resist prying, slicing and forced entry.
The BAK 80329 gives you locking, slash-resistant coverage when the bed is closed and a clear bed when it is rolled up, backed by a five-year limited warranty. Get it from Track Ready Products.
No drill, no cut. Vehicle-specific clamps and hardware come with the cover, and the install usually takes less than an hour.
Start with a clean set of rails. Position the cover, tighten the clamps evenly, and run it through a full open and close cycle to check that it moves freely and latches.
Care is simple: mild automotive soap and water for cleaning, a clamp check after about a week and periodically afterward, the cover secured whenever the truck is moving, and snow and ice cleared before you open it.
