Give the 2009-2018 Ram 1500, 2009-2025 Ram 2500/3500, 2010-2025 Ram 1500 Classic with an 8' bed a lockable hard cover with the BAK Revolver X4s 80214. The roll-up design opens the full bed in seconds and closes it back up under a locked, slash-resistant cover.
It builds on the Revolver platform with upgraded materials, better weather protection and an all-matte black finish.
On a Ram the bed is meant to be used, and a cover that locks, seals and still opens fully helps you use it.
Roll it back and the whole bed is yours. Safety straps secure the rolled cover, and it stays clear of the rear window and factory cameras while you drive. There are no panels to prop up or stow.
Level-3 security. The Revolver X4s is slash resistant, and patented rotational locking rails with automatic slam latches resist prying, slicing and forced entry. Close it and it locks.
Aluminum slats under one-piece vinyl. Patented interlocking aluminum slats sit beneath a seamless, aluminum-reinforced TriShield 70-grade vinyl surface with a matte finish that resists dust and stains. The slats support up to 400 lb of evenly distributed weight.
Low profile, tight seals. The cover sits nearly flush with the bed rails, and flush-fitting side seals plus an integrated bulkhead seal help keep water and dust out of the bed.
With a five-year limited warranty behind it, the BAK 80214 is a secure, full-access roll-up for your truck. Order it from Track Ready Products and match the bed length above before checkout.
No drill, no cut. Vehicle-specific clamps and hardware come with the cover, and the install usually takes less than an hour.
Start with a clean set of rails. Position the cover, tighten the clamps evenly, and run it through a full open and close cycle to check that it moves freely and latches.
Recheck the clamps after about a week, wash with mild automotive soap and water, and clear off snow and ice before opening. Keep the cover secured at all points whenever you drive.
