Give the 2024-2025 Toyota Tacoma with a 6'2" bed a lockable hard cover with the BAK BAKFlip MX4 448447. It folds forward against the cab for full bed access, then closes and locks to protect what you carry.
As a Gen 3 BAKFlip MX4, this cover raises the load rating to 400 lb and improves the seals and latching.
Tacoma owners tend to load the bed with camping, biking and trail gear, and a lockable cover keeps it secure at the trailhead and dry on the road.
Heavy-duty where it counts. Multi-layer aluminum panels, a high-density polymer core and precision-engineered side rails make this Gen 3 cover 22% stronger than the original MX4, with a 400 lb evenly distributed load rating.
Fold it up and haul. The cover folds forward and upright against the cab, with prop rod clips holding it in place and rubber bumpers protecting the cab. You can drive with it folded open, and the third brake light is not blocked in any position.
Sealed against the weather. Revised EPDM rubber perimeter seals and tight-fit clamps close the gap between the cover and the bed rails, and the dual-action tailgate seal, available on most applications, is 13% longer than before. An integrated drainage system carries water away.
Close it and walk away. The auto-latch does the locking, and the re-engineered lock components give this generation better resistance to forced entry than the last.
Textured matte black, flush to the rails. The finish carries across every component, and the cover sits flush with the bed rails, so it looks right whether it is open or closed.
Before you order: It requires the Toyota Deck Rail System. Also match the bed length shown in the fitment line above.
Assembled in the USA and covered by a five-year limited warranty, the BAK 448447 is the Gen 3 upgrade for owners who want a stronger, tighter-sealing folding cover. Order it from Track Ready Products and check the bed length above.
Bolt-on, click-in mounting keeps the install simple: one person, basic hand tools, usually 30 minutes or less, and the hardware is in the box.
Start with a clean set of rails. Position the cover, tighten the clamps evenly, and run it through a full open and close cycle to check that it moves freely and latches.
Care is simple: mild automotive soap and water for cleaning, a clamp check after about a week and periodically afterward, the cover secured whenever the truck is moving, and snow and ice cleared before you open it.
