The aFe MACH Force-Xp 304 Stainless Steel Clamp-on Exhaust Tip in black is a finishing piece for 3-inch exhaust tubing, built from 304 stainless steel with a black finish. The manufacturer's own page for the polished version of this tip line describes a 3" inlet, 4-1/2" outlet tip, and it carries a laser-cut aFe POWER logo plate riveted on. Compared with a stock tip or a cheaper mild-steel replacement, 304 stainless with a powder-free black finish is the better choice for a tip that sits in road spray and heat. The manufacturer states that a high-quality band clamp creates a complete 360-degree sealing surface, which helps the tip stay put and seal at the joint rather than rattling loose.
This is a universal-style clamp-on tip, not a vehicle-specific bolt-on part, so the key fitment check is the diameter of your existing exhaust tubing. The manufacturer says the tip line is designed for 3" exhaust systems, so confirm your tailpipe is 3" before ordering. For DIY installs, the manufacturer's aFe install guides call for letting the exhaust cool, leaving the clamps loose until the whole system is aligned, and re-tightening all exhaust clamps after 50-100 miles. Keep the tip at least 1/2" to 1" from body panels to avoid heat damage. Search terms this part matches include 3 inch black stainless exhaust tip, 304 stainless clamp-on tailpipe tip, aFe MACH Force-Xp tip upgrade, and 3 to 4-1/2 inch exhaust tip.
The manufacturer describes this tip line as designed for 3" exhaust systems rather than for a specific vehicle. Measure your tailpipe diameter before ordering. No vehicle-specific application was confirmed during research.
The manufacturer's product page for the polished version describes a mirror-polished finish, while this model uses a black finish. Both are listed as 304 stainless steel with the same 3" inlet and 4-1/2" outlet.
Owners on user forums have reported that the included band clamps can be hard to tighten enough and may strip or break. Some owners added a self-tapping stainless screw through each clamp as a backup. Inspect the clamp after installation and before you drive.
This is a clamp-on tip, so the work is mostly slipping the tip over the tailpipe end, centering it, and tightening the band clamp. Let the exhaust cool fully before you start, and wear gloves and eye protection. The manufacturer recommends keeping the tailpipe at least 1/2" to 1" from body panels to avoid heat-related damage. User forums report that the tip can extend past the tailpipe length you need, so dry-fit it and check the clearance before you tighten the clamp. Re-check the clamp after the first 50-100 miles, as the manufacturer recommends.