Mishimoto's low-temperature thermostat kit for the 2003–2007 Ford 6.0L Powerstroke arrives with the thermostat already seated in a 6061 CNC-machined aluminum housing. The manufacturer rates the unit to open at 185°F, against 192°F for the factory part, so coolant reaches the engine sooner. That earlier opening point is why the manufacturer recommends it for hot climates and heavy towing. Buyers searching for a 6.0 Powerstroke 185 degree thermostat, a CNC thermostat housing upgrade, or a 2004–2007 F-250 cooling refresh are looking at this part.
The machined housing is the main reason to pay more than a bare thermostat costs. The manufacturer says the aluminum body seals reliably and will not rust over time, which matters on a component that sits in the engine's coolant path. Owners on user forums point out that a thermostat-only version must be moved into the factory housing, while this kit arrives complete. The unit carries the Mishimoto Lifetime Warranty, which backs the durability claim.
The manufacturer lists installation difficulty as easy. Owners on user forums describe the job as roughly an hour's work, including the coolant drain, and note that the exhaust backpressure sensor bracket and a nearby fuel line crowd the housing nuts. A long extension with a swivel socket helps reach the fasteners. Coat the new O-ring in petroleum jelly so it stays seated during reinstallation.
Yes. The manufacturer lists one thermostat, one CNC thermostat housing, and one rubber O-ring for the housing in the box.
The manufacturer states the lower activation temperature lets coolant flow through the engine earlier, which helps maintain lower engine temperatures. It is a direct-fit replacement for the aged factory unit.
Details vary across sources on this point. The manufacturer states the thermostat comes pre-installed, so confirm with the manufacturer before ordering if you have questions about compatibility.
Plan on a moderate weekend job with basic hand tools. Drain the cooling system or clamp the upper radiator hose near the housing to limit spillage. Pull the air intake or charge-air-cooler tube if it blocks access, then remove the housing nuts and studs and move the exhaust backpressure sensor bracket aside. Watch the fuel line near the housing, since it can prevent a nut from turning until it is pushed clear. Before reinstalling, bleed the cooling system of air as the manufacturer and owners advise.