The H&R 70754 is a 28 mm front anti-roll bar for the BMW Z3 E36-chassis roadster and coupe, made from 50CrV4 spring steel and shot-peened and heat-treated for fatigue resistance. Its forged ends have two mounting holes, giving you a two-way stiffness adjustment in place of a fixed bar. A larger-diameter front bar resists body roll more firmly than the stock unit, so the car stays flatter through corners and the front end responds more quickly to steering input. Buyers looking for a BMW Z3 front sway bar upgrade, a 28mm adjustable anti-roll bar, or Z3 handling improvements will find this a direct, bolt-in answer.
Fitment covers the 4-cylinder and 6-cylinder Z3 models, but published model-year ranges differ between sources, so confirm your year and body style before ordering. The included urethane/Teflon composite bushings are designed to run without grease, which avoids the squeak and maintenance issues that often come with stock rubber on a lowered or coilover-equipped car. The bar mounts in the factory locations, so no custom brackets are needed. Owners doing this job on the Z3 typically remove the bushing brackets, let the bar drop, and then pull the control-arm bracket bolts to free it, so plan for limited working room under the car.
It is designed for 4-cylinder and 6-cylinder Z3 roadsters and coupes. Published model-year ranges differ between sources, with some listing 1996 to 2002 and others narrower ranges for coupe and M variants, so confirm your exact year and body style with the manufacturer before ordering.
Yes. The bar ships with H&R urethane/Teflon composite bushings, which are designed to operate without grease or lubrication.
This is a moderate-difficulty job that is well within reach of a home mechanic with a jack or ramps. Owners report that the bushing bracket bolts are 13 mm, the control-arm bracket bolts are 16 mm, and the end link nuts are 16 mm, with the lower end link bolt at 13 mm. A torque wrench helps, since owner write-ups list 22 ft-lb for the bushing bracket nuts and 44 ft-lb for the control-arm bolts. Expect rusted or seized end link fasteners, particularly the upper ones, and consider replacing the end links at the same time. Work in short steps, use penetrating oil, and make sure the bar is seated in the new bushings before final torque.