The Bilstein B4 22-138361 is a front OE-replacement twintube strut assembly for the BMW 5 Series E60 chassis, including the 2004 525i Base. It belongs to Bilstein's B4 line, which uses gas-pressurized twintube dampers meant to restore the ride, body control, and steering feel that worn factory struts lose over time. Cheap bargain struts often leave a soft, bouncy front end after a few years, so the B4 suits an owner who wants the E60's original character back without changing the car's setup. Because it arrives as a complete strut, you avoid reusing the old damper internals.
Fitment details vary across sources. Some list the 525i for 2004 through 2007, while others pair this strut with 2004 to 2005 545i and 2006 to 2010 550i applications, so confirm against your VIN before ordering. Owners on user forums say you should replace the strut mount along with the strut, and that left and right units are not interchangeable. Shoppers searching for an E60 525i front strut replacement, a 22-138361 twintube strut, or a Bilstein B4 OE strut for a BMW 5 Series will find this part matches those applications.
Owners on user forums say yes. One owner called replacing only the struts without the mounts a mistake, noting the mount must turn freely once torqued to spec.
Owners on user forums advise replacing both fronts and having a steering alignment done afterward.
Owners on user forums report reusing the original springs when only the struts were replaced, generally when the springs are in good condition.
Owners on user forums describe this as a manageable driveway job for someone comfortable compressing a coil spring, though not a quick swap. One owner estimates about 30 to 40 minutes per side in a garage. A plate-style spring compressor is the safer choice, since forum users report that stick-type or bench-vise compressors often do not fit the E60 well. Tape the fender before you work, because clearance is tight when pulling the strut. On AWD cars, disconnect the passenger-side headlight level arm first or you risk snapping it. Anti-seize on the strut helps it seat into the knuckle, and the strut mount should spin freely after torquing before you call the job finished. Plan on a wheel alignment afterward.