The OMP TRS-E XL is the larger-bodied version of OMP's entry-level TRS-E family, with a tubular steel frame, medium-height side bolsters, and fully padded jacquard velour. It is FIA 8855-1999 homologated and HANS compatible, so it is a legitimate competition seat rather than a street-only upgrade. Drivers who are taller or broader than the standard TRS-E will benefit most from the extra shoulder width, base width, and seat depth, and the removable leg cushions let you fine-tune comfort on long sessions.
Compared with a stock seat or an uncertified budget bucket, this seat gives you a certified steel shell and a documented FIA rating for club racing, track days, and time-attack builds where harness-based restraint matters. It is a universal seat, so it is not a plug-and-play swap for any one chassis. Plan on side-mount brackets or a seat base sized to your car, and check the dimensions before ordering. Search terms it targets include FIA 8855-1999 XL bucket seat, HANS compatible racing seat, side-mount W-type racing seat, and 5-point harness XL race seat.
The manufacturer describes the seat as universal. It needs side-mount brackets that attach to the floor, or a seat mounting base and track set made for your specific vehicle. Measure your car and confirm the seat size fits before buying.
No. The manufacturer lists the XL as side-mount only, so bottom-mount brackets used on the standard TRS-E sizes do not apply to this model.
Per the manufacturer's dimension data, the XL measures 625 mm across the shoulders versus 585 mm on the TRS-E, a 540 mm base width versus 510 mm, a 415 mm inner belt-hole width versus 390 mm, and a 520 mm bottom length versus 470 mm.
Installation is a moderate-to-advanced job that depends on your bracket and base choice. Because the seat is universal, owners on user forums report that OMP side brackets often do not line up with a third-party seat base's bolt pattern, so you may need to mark and drill new holes before the seat sits correctly. Owners also note that OMP side brackets have multiple adjustment holes for height and angle, and that the seat can sit below or between the side brackets, which helps when you want a lower seating position. Forum builders who wanted the seat very low reported notching base plates or fabricating custom brackets, so plan for fabrication if you need significant height changes. Test-fit everything before final torquing, confirm that the seat belt anchors and harness route clear the seat, and follow the manufacturer's bracket installation instructions for your specific mounts.