This 15-inch Medium is a full-containment racing seat with a one-piece lightweight FRP composite shell, certified to FIA 8855-1999 with the hologram affixed. The containment design is what separates it from a basic bucket: full containment right and left head support halos add side-impact head protection, and the seat accommodates all head and neck restraint devices. Energy-absorbing memory foam in the back and seat cushions and a black mesh fabric cover for breathability make it more practical for long track sessions than a stock seat, and the extra thigh and hip support helps hold the driver in place during hard cornering. Search terms: FIA 8855-1999 full containment seat, 15 inch medium racing seat, 96993399RQP.
Fitment is side-mount. The manufacturer states there are four built-in 8mm side mount threaded fasteners (brackets not included), so budget for a bracket set before you buy. Optional RaceQuip Seat Mount Brackets allow 0° to 30° layback, which lets you tune recline for your driving position. The seat has five seat belt guides that handle 4, 5 or 6-point harnesses, so it works with most race harness configurations. Confirm the bracket and bolt spacing against your chassis mounting points, and check the seat against your sanctioning body's rules before installing. Owners on user forums typically mention that the mounting setup is where most of the install effort goes.
No. The manufacturer states the seat has four built-in 8mm side-mount fasteners, but brackets are sold separately. Optional RaceQuip seat mount brackets are the manufacturer's option for adjusting layback from 0° upright to 30°.
The manufacturer specifies five seat belt guides that handle 4, 5 or 6-point harnesses. The seat also accommodates head and neck restraint devices.
The manufacturer certifies this seat to FIA 8855-1999, with the FIA hologram affixed. Confirm that your sanctioning body accepts this standard before purchasing.
Installation is a moderate-difficulty job that requires a calibrated torque wrench, a level, and shims. Use all of the mounting locations your vehicle provides, torque every bolt to specification, and use washers so bolts do not pull through the fiberglass shell. Shim the seat until it sits level and square, and route any wiring away from moving or hot components. Because the seat is sold without brackets, confirm the bracket fit for your vehicle before ordering, and verify harness mounting points after the seat is fixed in place.