The aFe PROGUARD HD oil filter (Pro GUARD D2 line), sold here as a four-pack under 44-LF037-MB, is a spin-on canister filter with a steel shell. These oil filters utilize a high performance synthetic media for maximum filtration with minimal flow restriction, according to aFe's own product page. That matters for buyers running extended drain intervals or frequent spirited and track use, since a filter that keeps oil flowing while catching fine debris costs less than the engine wear it prevents. Before ordering, confirm this part's application for your specific year and engine. The manufacturer identifies 44-LF037 as a direct OE replacement filter for Toyota 90915-YZZD1. Application lists for this MPN differ across sources, so check the manufacturer's fitment data or your VIN for a 2006-2015 MX-5 Miata.
For a DIY oil change on an NC-generation Miata, the filter access is the main chore. Look further back in the center of the car and you will see a plate held on by 5 bolts. Undo the bolts and you can access the filter without any problem. Owners on user forums also suggest a zip-top bag over the filter before unscrewing it, since you will catch the oil that will otherwise pour out on top of you. Searchers looking for an NC Miata 2.0 oil filter swap, a 3/8" ratchet-drive oil filter, a synthetic ISO-tested canister filter, or a bulk four-pack for extended interval oil changes should find this listing relevant.
The manufacturer describes 44-LF037 as a direct OE replacement for Toyota part 90915-YZZD1, and application lists for this part number vary across sources. Verify fitment for your exact model year and engine against the manufacturer's application data or your VIN before ordering.
Owners on user forums say you generally don't need to. The filter is reached by removing a center access plate held by five bolts.
User forums recommend slipping a zip-top bag over the old filter before loosening it, and some owners use a cut-down plastic bottle as a catch container while the filter comes off.
Plan on a 3/8" ratchet for the built-in boss, a filter wrench as backup if the old filter is stuck, a drain pan, rags, a zip-top bag, and a jack with stands or ramps. Warm the engine for a few minutes so the oil drains faster, then drain it and reinstall the drain plug with a new crush washer, snug only. Before installing the new filter, confirm the old rubber O-ring came off with the old filter, since a stuck O-ring causes leaks. Lightly coat the new O-ring with fresh oil, thread the filter on by hand, and then tighten it only slightly past seating. Start the engine and check for leaks at the filter and drain plug.