Red Line's 41005 is a one-gallon jug of two-cycle snowmobile oil that can be mixed into gasoline or run through an oil-injection pump. The manufacturer says it was designed to satisfy the low-temperature viscosity requirements of some newer sleds, specifically the Arctic Cat. It is a low-smoke, biodegradable formula with excellent cold flow that injects down to -40°F, and its low-ash chemistry is meant for latest direct-injection two-stroke engines.
Why pay more than for a generic two-stroke oil? Owners on user forums note that marine oil can thicken in cold weather, which makes a snowmobile-rated oil the safer choice for an injector. The manufacturer says the oil maintains viscosity for low-temperature injection at temperatures as cold as -40°F for extended periods. Its formula is also said to allow for cleaner spark plugs, pistons and exhaust, while providing significantly longer bearing life.
Mix ratio is where most owners go wrong. The manufacturer's technical literature leaves the ratio to the engine builder, since it depends on bearing and piston design, piston clearance, RPM and air:fuel ratio. Owners on user forums describe running anywhere from 35:1 to 40:1, and some mention 36:1 premix. If your sled is injected, the service manual calls for a bleed procedure whenever the sled has been on its side, the reservoir has run dry, or oil lines have been replaced. Shoppers searching for Arctic Cat injection oil, -40°F two-stroke premix or snowmobile oil pump bleed info will find this relevant.
Yes. The manufacturer states the oil is intended for use both as a pre-mix and as an injected oil in snowmobiles.
The manufacturer markets this oil for snowmobiles. Owners on user forums report running snowmobile-grade two-stroke oil in chainsaws, trimmers and blowers without problems, but one forum user advises that hot, modified saws may be better served by a racing two-stroke oil. Check your engine's requirements before switching.
The manufacturer says its two-cycle lubricants help stabilize fuel and prevent rust during seasonal storage.
There is no mechanical installation. Pre-mixing takes a clean fuel container, a marked measuring vessel and a funnel, and the manufacturer leaves the ratio to the engine builder, so confirm it against your sled's manual before mixing. For injected sleds, owners on user forums recommend watching spark plug color and checking for oil dripping from the exhaust as a sign the ratio or injector flow needs adjusting. After the reservoir runs dry or lines are replaced, follow the service manual's bleed procedure before riding.