Red Line's 60WT Drag Race Oil, sold as the one-gallon 10605, is a full-synthetic 20W60 built for competition engines. The manufacturer's chemistry is based on ester base fluids, which it credits with holding film strength when excess fuel dilution is present. Its stated audience is racers in Top Alcohol and Pro Mod classes, AHDRA Nitro bike teams, and blown alcohol tractor pullers. Along with the 20W60 grade, the typical-properties sheet lists a 158 viscosity index and a -40°C pour point, and the maker says its race oils deliver 2-4% more power than oil of similar viscosity. Zinc and phosphorus are the main anti-wear additives, at about 2,250 and 2,000 ppm respectively.
Search terms for this oil usually include 20W60 race oil gallon, 60WT drag race oil, methanol fuel dilution oil, Top Alcohol Pro Mod oil, and high-zinc flat tappet break-in oil. Fuel-diluted oil can be heated to drive off the fuel and then reused, which lowers the cost per race for teams that run heavy fuel dilution. Because the manufacturer lists a 2,250 ppm zinc level and recommends the oil for valvetrain wear control, it is positioned as a step above a generic straight-weight race oil. Fitment depends on the engine and the class rules rather than a specific vehicle, so confirm your sanctioning body's oil requirements before you race.
The manufacturer states that the oil can be heated to evaporate fuel dilution and then reused. Confirm your own fuel-dilution limits before reusing it.
The manufacturer's typical-properties sheet lists an average of 2,250 ppm zinc and 2,000 ppm phosphorus.
Owners on user forums commonly say a high-zinc break-in oil matters most for flat-tappet cams, since the cam lobe and lifter contact relies on anti-wear additives. The manufacturer's zinc level makes this oil relevant to that use, but confirm with the manufacturer whether it is specifically recommended for break-in.
This is a standard oil change, so the job is a drain, filter swap, and refill with a drain pan, filter wrench, and funnel. The main gotcha is the break-in sequence for flat-tappet engines. Owners on user forums describe running the engine at roughly 2,000 to 2,500 RPM for about 20 to 30 minutes, since slower speeds may not deliver enough oil to the camshaft. Many also recommend changing the oil and filter soon after break-in, sometimes around 100 miles, before moving to your regular oil.