The H&R 51676 is a lowering spring kit for the 2010-2012 Ford Fusion S, SE, SEL and Sport in 2WD form, covering both the 4-cylinder and V6 engines. Owners on user forums describe a 1.6" front and 1.9" rear drop with this kit, which closes the wheel-well gap on a stock Fusion without the cost of a coilover conversion.
The reason to pay for H&R over a cheaper no-name spring is ride quality. A 2010 Fusion Hybrid owner on a user forum found the drop more aggressive than earlier Eibach setups, yet the ride stayed far more compliant and really not that far off from stock, with the handling not quite as tight, a fair trade for a daily driver. Another forum owner reported that the handling has improved dramatically while the car still felt much like it did from the factory.
Because this listing is specific to 2WD models, confirm your drivetrain before ordering, especially if you are shopping for an AWD Fusion. Owners on user forums have fitted H&R springs to the Fusion Hybrid, so searches like "2010 Fusion Hybrid lowering springs" and "H&R 51676 Fusion sport spring" lead to real-world reports. Plan to verify your ride height after installation and get an alignment, since lowered springs change suspension geometry.
Owners on user forums report roughly 1.6 inches at the front and 1.9 inches at the rear. Results vary with the vehicle's setup and the figures are not confirmed by the manufacturer here, so verify with the manufacturer before ordering.
Owners on user forums say the ride is noticeably more compliant than they expected, close to stock for daily driving, with handling a little less tight than a firmer setup.
Owners on user forums have installed H&R lowering springs on a 2010 Fusion Hybrid and reported a more aggressive drop than earlier setups. Confirm fitment with the manufacturer for your exact model.