The H&R 29300 is a four-spring Sport Spring kit for the 2003–2008 Jaguar S-Type R Supercharged, built on progressive-rate coil springs that replace the factory springs. The manufacturer's application data lists about 1.4 inches of front drop and 1.3 inches at the rear, which closes the wheel-well gap that the stock ride height leaves on this car. Owners on user forums who kept the factory CATS dampers describe the ride as firmer but not bouncy, with better cornering control, so the kit suits drivers who want a sharper stance without giving up daily comfort.
The manufacturer's application listing covers only the supercharged R, so base-model S-Types are not part of this fitment. Owners on user forums report mixed results with aftermarket dampers, so check your shock setup before you commit to a stiffer ride. Plan on a wheel alignment after installation, since the lower ride height changes camber and toe. Keywords: 2003-2008 S-Type R supercharged lowering springs, H&R 29300 front and rear drop, progressive rate sport springs, S-Type R CATS dampers, fender gap fix.
The manufacturer's application data lists only the 2003–2008 S-Type R Supercharged for part 29300. Base-model S-Types are not listed, so confirm with the manufacturer before ordering for any other trim.
Owners on user forums mention the 29300-1 suffix for this car, and details vary. Confirm the correct part number with the manufacturer before ordering.
Owners on user forums report that the factory CATS dampers work well with these springs, while one owner found a non-CATS Bilstein too soft on stock springs. Experiences vary, so confirm damper recommendations with the manufacturer.
Owners on user forums say the front swap takes roughly five removal steps and five reinstallation steps per side, and the rear is shorter, so this is a manageable driveway job for someone comfortable with suspension work. You will need a proper spring compressor and standard hand tools to separate the strut assembly. Do not skip the wheel alignment afterward, because the lower ride height changes the geometry.