If you own a 2025 or 2026 Toyota 4Runner SR5 4WD non-hybrid with the 2.4L turbo, this front spring set targets that configuration. Eibach's PRO-LIFT-KIT springs raise the front end without coilovers or spacer blocks, and the company builds them with the same off-road race spring engineering used in its ERO race springs. Because the lift comes from the spring itself, the design avoids the added strain on bushings and ball joints that spacer systems can introduce.
Compared with stock springs, this set adds front ground clearance and fender room for larger tires while aiming to keep on-road ride quality intact. Owners on user forums report that a clean front-only change works best when the rear height is also checked, so plan your suspension build around the 4Runner's total stance. Warranty terms should be confirmed with the manufacturer before purchase, since coverage details vary across Eibach's Pro-Lift listings. Search terms: 2025 4Runner SR5 2.4T front lift springs, 2026 4Runner non-hybrid front lift, Eibach 4Runner front coil springs.
The manufacturer's install sheet for a related 4Runner TRD Pro spring set says to retain the original stock isolators and dampers. Confirm the same applies to this part before reusing them.
The manufacturer's install sheet for a related 4Runner spring set advises inspecting and adjusting wheel alignment, fender clearance, brake line clearance, and ABS sensors after installation.
The manufacturer's instructions for related 4Runner springs call for qualified suspension technicians, so this is a job best suited to experienced DIYers with a hoist or solid lift. Plan on a spring compressor, jack stands, and a second jack, which make the job easier. Install each spring with the Eibach logo facing up. Owners on user forums report that a spring compressor can be tight to remove once the spring is compressed, and one owner took about six hours solo on an earlier 4Runner Pro-Kit install. Recheck torque on all fasteners after the first few hundred miles. Lift height can vary with vehicle manufacturing tolerances, so verify the final stance and alignment after installation.
