The Eibach Pro-Kit E10-72-008-01-22 is a set of four progressive coil springs made for the 987-generation Porsche Cayman. The manufacturer lists it for 2006 through 2012 cars and says it was tested with factory dampers, so it replaces only the springs and leaves the original shocks in place. Lowering the ride height brings the center of gravity down, which owners on user forums say reduces nose-dive under braking and body roll in fast corners. It is a sensible pick for a street or occasional track car that needs a firmer, more controlled stance without the cost of a coilover conversion, and it gives a known application-specific drop rather than a guessed one from a generic spring.
Fitment details matter on this platform. The manufacturer notes that 2008-and-later Cayman cars with 6mm isolator pads need 3mm Porsche isolator pads to achieve the correct lowering. Owners on user forums report that lowering a 987 raises negative camber and changes steering feel, so a full four-wheel alignment after installation is essential, and some have found the front bumper scraping on steep driveways. Searches like 987.1 Cayman S lowering springs, 987.2 Cayman Pro-Kit install, and E10-72-008-01-22 alignment specs point to the exact application this kit targets.
The manufacturer states that 2008+ Cayman cars equipped with 6mm isolator pads require 3mm isolator pads from Porsche to achieve the correct lowering height.
The manufacturer says the kit was tested with factory dampers. Its guidance also recommends replacing worn standard shocks, or upgrading to sport shocks, when fitting lowering springs.
Yes. Owners on user forums consistently report that lowering increases negative camber and changes toe, and the manufacturer's general Pro-Kit instructions call for a full vehicle alignment to factory specifications after installation.
The manufacturer's general Pro-Kit instructions say to keep the original isolators, dampers, and tubing from the stock springs and to install each spring with the Eibach logo facing up. Lift and support the car on proper safety stands, never on a jack alone, and consult the factory manual for jacking points. Once the springs are in, the rear bushing pivot points should be retorqued with the full weight of the vehicle on the suspension to prevent bushing pre-load. Given the front strut work and rear suspension torque sequence, most owners treat this as an intermediate job for an experienced home mechanic, though a shop with Porsche experience is worth seeking for the alignment. Verify bump stop clearance before driving, since the bumper scraping reported by owners suggests the stock bump stops and upper mounts may need checking.